Carpet Application Instructions

EZ No Slip™ Carpet, Mat and Area Rug Coating Instructions

EZ No Slip™ Carpet, Mat and Area Rug Coating can be applied to any type of material for anti-slip against any type of surface.

Preparation

The back of the rug, carpet or mat should be completely dry and free of dirt, debris and oil or grease prior to application. Thoroughly vacuuming the surface to be coated is recommended.

Application

  1. Lay the EZ No Slip™ jar down on its side and roll it back and forth vigorously to fully mix the aggregate.
  2. Pour the product into the provided paint tray and apply it to the back of the rug, carpet or mat.
  3. Roll or apply the product evenly back and forth over the surface at a steady pace, making sure not to coat the product too heavily or apply too much pressure on the roller. When applying, avoid heavy buildup, puddling and overlapping.
  4. Swirl the liquid in the paint tray occasionally to keep aggregate evenly mixed throughout the solution.

Important: Bubbling and Drying

If bubbling occurs on the surface when applying, allow the solution to settle for several minutes before continuing. If necessary, bubbles can be “popped” when the solution is wet by blowing on the surface or applying air pressure (i.e., with a hair dryer). Bubbles will also be caused by rolling the liquid back and forth too fast.

The surface should be left to dry at 70°F and 50% relative humidity. Allowing an overnight cure time is highly recommended. Do not apply at temperatures below 50°F or above 90°F.

Cleaning

Clean your tray and roller with warm water. If you get any EZ No Slip™ on the floor or another surface, simply wipe it up with a damp, warm cloth as needed.

DO NOT use harsh chemicals, as this product is water-based and eco-friendly.

Warning and Maintenance

Allow 24 hours for full cure before putting the coated surface down on the floor or another surface.

  • DO NOT clean EZ No Slip™ treated surfaces with highly abrasive tools such as scouring pads or abrasive sponges. Over-abrasion will damage the surface of the coating, removing the non-slip textured aggregate.
  • Harsh chemicals will damage the surface appearance, giving it a brownish tinge.
  • DO NOT use chemical solvents to clean, as they may dissolve the coatings.

Use of any of the listed “DO NOT use” or “DO NOT clean” cleaning methods or solutions releases the manufacturer from any guarantees of performance and voids the manufacturer's limited warranty.

Limited Warranty

GOOD PLANET PRODUCTS LLC WARRANTIES THAT THE SURFACE TREATMENT AND PROTECTION COATING WILL PERFORM AS CLAIMED WHEN USAGE DIRECTIONS ARE CAREFULLY FOLLOWED. USER IS SOLELY RESPONSIBLE FOR DETERMINING SUITABILITY FOR INTENDED USE AND ASSUMES ALL RISKS IN CONNECTION THEREWITH OTHER THAN AS WARRANTED HEREIN. WARRANTY EXTENDS TO ORIGINAL PURCHASER AND MAY NOT BE ASSIGNED OR TRANSFERRED. THE WARRANTY PROVIDES NO LIABILITY FOR ANY INCIDENTAL OR CONSEQUENTIAL LOSS OR DAMAGE. THE LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES INCLUDING MERCHANTABILITY, FITNESS FOR USE OR FOR A PARTICULAR PURPOSE.

Warning

KEEP OUT OF THE REACH OF CHILDREN.

Contact Information

Good Planet Products LLC
Email: info@eznoslip.com